Kohler K-1914-GR-47 Installation Guide download pdf (Page 5)

Operating Your Bath

Using the Bath

NOTE: A removable label is included with the literature packet. It should be applied over the door switch

as a reminder on how to operate the bath.

With the door lowered, turn on the water and adjust it to the desired temperature. The water will

run into the footwell and exit through the sidewall drain and toe tap drain (if open) until the door

is closed.

Enter the bath and close the toe tap drain located in the footwell.

Lightly grasp the handle recess and raise it until the latches on each side of the door engage. The

drain valve will close and the seal will begin inﬂating.

IMPORTANT! If water does not cover the level sensors within 2 minutes, the drain valve will open

automatically.

Immediately add water to the bath until it is above the level sensors.

Fill the bath until the water is midway up the sidewall. More water can be added if you choose to

bathe without turning on the blower.

Airjet Operation

Press the On/Off button on the user keypad to turn on the blower motor.

After approximately 20 minutes of continuous operation, the blower motor will stop. If desired,

press the On/Off button to restart the blower motor.

If desired, press the up or down arrow buttons to change the air ﬂow rate.

When ﬁnished bathing, press the On/Off button a second time to turn off the blower motor.

Toe Tap Drain

Door Switch

Handle

Footwell

Sidewall Drain

Airjets

User Keypad

Purge Mode

On/Off

Increases Flow

Decreases

Flow

Level Sensors

Label

1 - To Drain

Press button once

and

press floor drain

2 - To Exit

When drained,

lift latch on outside

of rising wall

Kohler Co. 5 1128535-5-G

1 2 3 4 5 6 7 8 9 10 ... 67 68

Comments to this Manuals

No comments

Kohler K-1914-GR-47 Installation Guide Page 5

Comments to this Manuals

Related products and manuals for Unknown Kohler K-1914-GR-47