Kohler K-1914-GR-47 Installation Guide download pdf (Page 8)

Maintenance

For best results, perform the following maintenance steps periodically.

•

Use a can of compressed air to clean off the seal surface.

•

Apply a drop or two of oil to the lower face of the striker plate mounted on either side of the bath.

This is the surface that the latch pins strike when the door is raised. Light oiling will help improve

performance.

•

Occasionally wipe off the level probes to keep them clean. This will help improve the system

response time as the water drains from the bath.

•

For commercial applications, Kohler Co. recommends periodic maintenance of the door seal by a

Kohler Co. Authorized Service Representative (ASR) or a qualiﬁed installer every 3 to 4 years or if

any of the symptoms in the ″Troubleshooting″ section occur.

Care and Cleaning

Do not use powdered cleaners unless the cleaner is fully dissolved in water. Solid substances

could block the airjets.

Do not use full strength bleach or ammonia cleaning solutions. Chemically active cleaning

solutions can damage the bath surface.

Do not use abrasive cleansers or solvents on acrylic surfaces. Abrasive cleaners and solvents can

damage the bath surface.

Wipe out your acrylic bath with a soft cloth after each use.

Avoid detergents, disinfectants, or cleaning products in aerosol cans.

NOTE: To restore dull or scratched units: Apply white automotive polishing compound with a clean rag.

Rub scratches and dull areas vigorously. Wipe off residue. Follow with a coat of white automotive paste

wax. Do not wax areas where you walk or stand.

Cleaning Your User Keypad and Remote Control

Use a soft cloth to wipe the keypad and remote control after each use. If the surface becomes dirty,

use a non-abrasive soap and warm water to clean.

Maintaining the Airjets

If cleaning the airjets is required due to hard water deposits, use a small between-the-teeth dental

brush and white vinegar. Dip the brush in the vinegar, brush the hole, rinse the brush in clean

water, and then use the wet rinsed brush to rinse the hole.

Fill the bath with water to the top row of airjets. Drain the bath and press the purge button.

For detailed cleaning information and products to consider, visit www.kohler.com/clean. To order Care &

Cleaning information, call 1-800-456-4537.

Warranty

Ten Year Limited Warranty for the Bath Component

Lifetime Limited Warranty for the Inﬂatable Door Seal Component

One-Year Limited Warranty on all other components

Kohler Co. warrants the bath component of the Elevance Wall Bath manufactured after September 1, 2010, to

be free of defects in material and workmanship during normal residential use for ten years from the date of

installation. Kohler Co. warrants the inﬂatable door seal component to be free from defects in material and

workmanship during normal residential use for as long as the original consumer owns his or her home,

provided the Elevance Wall Bath is installed by a qualiﬁed installer. Kohler Co. warrants all other

components to be free from defects in material and workmanship for one-year from the date of installation.

1128535-5-G 8 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 67 68

Comments to this Manuals

No comments

Kohler K-1914-GR-47 Installation Guide Page 8

Comments to this Manuals

Related products and manuals for Unknown Kohler K-1914-GR-47