Kohler K-1997-4-0 Installation Guide download pdf (Page 7)

3. Prepare the Shroud Installation

If you are not installing a shroud with your sink, proceed to the next

section.

NOTE: This product is heavy. Get help when lifting and securing

the shroud.

With assistance, carefully position and center the shroud tight

against the underside of the sink. Mark the three shroud hole

locations on the ﬁnished wall.

Carefully remove the shroud and sink.

Draw a level line connecting the top shroud hole marks. Measure

3-1/2″ (89 mm) on each side of the centerline to mark the top two

angle bracket holes.

For the bottom angle bracket hole, measure and mark the

centerline 1-5/8″ (41 mm) above the bottom shroud hole mark.

Use lag bolts (not provided) to secure the three angle brackets to

the wall at the marked locations.

Lag Bolt

1-5/8"

(41 mm)

Angle Bracket

Holes

Sink Anchor

Holes

3-1/2" (89 mm)

3-1/2"

(89 mm)

Shroud

Holes

Kohler Co. 7 1208746-2-A

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

No comments

Kohler K-1997-4-0 Installation Guide Page 7