Kohler K-2175-1-7 Installation Guide download pdf (Page 5)

2. Install the Lavatory

Drill 1/4” mounting holes at the marked locations on the ﬁnished

wall and the ﬂoor.

NOTE: You can also use other fastening devices of sufficient size

and strength.

Install the hanger bolts to the backing material so they extend 3/4”

(1.9cm) beyond the ﬁnished wall.

Install the faucet and drain to the lavatory according to the

manufacturer’s instructions.

CAUTION: Risk of product damage. Do not overtighten the

wood screw. Overtightening may damage the product.

Move the pedestal over the drilled hole in the ﬂoor, and secure the

pedestal to the ﬂoor by carefully tightening the wood screw and

washer.

Carefully set the lavatory on the pedestal so the hanger bolts extend

through the lavatory anchoring holes.

CAUTION: Risk of product damage. Do not overtighten the cap

nuts. Overtightening may damage the product.

Install the cap nuts and washers to the hanger bolts. Level the

lavatory, and carefully tighten the cap nuts until snug.

Kohler Co. 5 1016180-2-A

1 2 3 4 5 6 7 8 9 10 ... 19 20

No comments

Kohler K-2175-1-7 Installation Guide Page 5