Kohler K-702412-L-MX Installation Guide download pdf (Page 6)

3. Locate the Wall Jambs

Position the wall jamb ﬂat against the wall with the base of the jamb centered on the shower

threshold.

NOTE: Some ﬁling may be required of the bottom edge of the wall jamb if your bath unit has rounded

corners.

Plumb the wall jamb into position using a level.

Temporarily secure the level position of the wall jamb with several pieces of masking tape.

Make a pencil mark at the four pre-drilled hole locations in the wall jamb.

Remove the masking tape, then remove the wall jamb to an out of the way place to prepare for

drilling of the four holes.

Slowly drill the marked hole location with a 5/16″ drill bit. If drilling through ceramic tile, use a

masonry drill bit.

NOTE: When installing on ceramic tile, use a center punch to lightly ″nick″ the surface of the glaze. Tap

the center punch lightly with a hammer to avoid cracking the tile.

Insert a wall anchor into each hole.

Reposition the wall jamb over the installed wall anchors.

Secure the wall jamb loosely onto the wall with the four # 8-18 x 2″ provided screws.

NOTE: NOTE: Thoroughly clean and dry all dust, dirt, and grease from the bottom track and shower

ledge surfaces.

Repeat the procedure for the opposite wall jamb, taking care to make sure it is directly opposite the

ﬁrst installed wall jamb.

Wall Jamb

Drill holes.

#8-18 x 2"

Wall Anchor

Press and hold legs together.

Measure here.

Wall

Jamb

1036565-2-D 6 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 ... 47 48

No comments

Kohler K-702412-L-MX Installation Guide Page 6