Kohler K-702412-L-MX Installation Guide download pdf (Page 8)

4. Seal and Install the Bottom Track

Thoroughly clean and dry all dust, dirt, and grease from the bottom track and shower ledge

surfaces where the bottom track will sit and the silicone sealant will be applied.

Measure from the left side stop in the wall jamb to the right side stop (dimension A).

Using a pencil, mark dimension A on all three sides of the bottom track.

Along the inside edge of the pencil marks, place a piece of masking tape.

Carefully cut the bottom track along the masking tape edge.

Use a ﬁle to remove the rough edges along the cut.

Remove the masking tape.

NOTE: When positioning the bottom track in the wall jambs, move the inside edge of the bottom track

against the small stop ﬁrst. Then gently push the entire bottom track down until the outside edge is in

position against the wall jamb and the threshold .

Insert the bottom track between the two wall jambs to check for proper ﬁt. The outside of the

bottom track (high side) should face toward the outside of the shower. The inside end of the bottom

track should ﬁt snugly against the back edge of the wall jamb (Inside of Shower)

Remove the bottom track from the wall jambs.

Apply silicone sealant in the groove located on the underside of the bottom track.

Reinstall the bottom track.

Secure the bottom track in place with masking tape.

Apply sealant here.

Bottom Track

Wall Jamb

Top View

Side View

Bottom Track

Outside of

Bottom Track

Stop

Mark "A"

Apply masking tape

with edge on mark.

Cut at "A".

Bottom Track

1036565-2-D 8 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 47 48

No comments

Kohler K-702412-L-MX Installation Guide Page 8