Kohler K-1914-GRW-0 Installation Guide download pdf (Page 18)

8. Disconnect the Components

Installations Requiring Disassembly Only

Disassembly Checkpoint #3

The steps below may not be necessary. It is only required for doorways less than 31″ (787

mm). Make sure removing the bath from the frame is required. The bath likely can be

moved into place while attached to the frame.

If the bath can be moved into place without further disassembly, go directly to the

″Position the Bath″ section.

IMPORTANT! Save and organize all screws and hardware. All parts will be reused.

Disconnect the water inlet from the drain valve by loosening the nut. Save the O-ring.

Disconnect the blower connections by loosening the nut.

Disconnect the wire from the back of the blower keypad.

Disconnect the level sensing wires at the controller.

Disconnect the limit switch wires at the controller.

Disconnect the door power wire at the controller.

Disconnect the Bath from the Frame

IMPORTANT! Be careful not to strip or damage the screws when removing them. When the bath is

reattached they will be reused, as will the original holes in each of the wood blocks.

Disassemble the bath from the support frame at the four brackets by removing the two screws.

Nut

Remove all screws

from (4) brackets.

Disconnect level sensing wires.

Bracket

Wood Block

and

Disconnect limit switch wires.

Disconnect drain valve power.

Disconnect door power.

Water Inlet

Power Cord

Drain Valve

Controller

Open

1128535-2-F 18 Kohler Co.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 167 168

No comments

Kohler K-1914-GRW-0 Installation Guide Page 18