13. Install the Mounting Brackets and Pulley Assemblies
Installations Requiring Disassembly Only
NOTE: These steps are not required if the mounting brackets and pulley assemblies were not removed in
a previous step. If the mounting brackets and pulley assemblies were not removed, proceed to the ″Install
the Door ″ section.
Install the Mounting Brackets
Align a mounting bracket with the holes in the bath.
Use the four previously removed blue screws to secure the mounting bracket to the bath.
Adjust the mounting bracket so it is centered in the slots or out as far as the slots allow.
Tighten the screws.
Repeat with the second mounting bracket.
Install Pulley Assemblies
Install Mounting Brackets
Red
Screw
Blue
Screw
Pulley
Assembly
Mounting
Bracket
Slot
Slot
Limit Switch Wires
1128535-2-F 26 Kohler Co.
Comments to this Manuals