Kohler Command CV730 User Manual download pdf (Page 137)

8.21

Section 8

Electrical System and Components

Figure 8-33. Connections for Testing Charging System.

Figure 8-32.

3. Plug the tester into the proper AC outlet/power

supply for tester being used. Turn on the power

switch. The ‘‘POWER’’ light should be

illuminated and one of the four status lights may

be on as well. See Figure 8-26. This does not

represent the condition of the part.

4. Press the ‘‘TEST’’ button until a “click” is heard

and then release. See Figure 8-27. Momentarily

either the ‘‘HIGH’’, ‘‘LOW’’, or ‘‘SHORT’’ light

will flash.

a. If the “HIGH” light flashes on/off, the part is

good and may be used.

b. If any other light is displayed* the rectifier is

faulty and should not be used.

*NOTE: A flashing “LOW” light can also occur as a

result of an inadequate ground lead

connection. Make certain connection location

is clean and clamp is secure.

DC Voltmeter

Rectifier-Regulator

Flywheel

Stator

Ammeter

Battery

(-)

(+)

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 216 217

No comments

Kohler Command CV730 User Manual Page 137