Kohler K-1913-LW-47 Installation Guide download pdf (Page 38)

21. Install the Finished Wall

All Installations

If you have not already done so, carefully remove any protective tape from the bath rim, access

panel and trim caps.

NOTE: Use the provided template (if needed) to cut the bottom of the wall material to match the contour

on the rear of the bath.

Cover the framing with water-resistant wall material. Seal the joints between the bath rim edge and

the water-resistant wall material with silicone sealant.

Tape and mud the water-resistant wall material. Install the ﬁnished wall to the water-resistant wall

material so it is 1/16″ (2 mm) above the bath surface. Seal the joints between the bath rim and the

ﬁnished wall material with silicone sealant.

Install the faucet trim according to the instructions packed with the trim.

Troubleshooting

This section is for general aid only. A Kohler Co. Authorized Service Representative or qualiﬁed electrician

should correct any electrical problems. For warranty service, call 1-800-4KOHLER from within the USA and

Canada, or 001-800-456-4537 from within Mexico.

Normal Operation Includes:

While ﬁlling the bath with water, some water is routed to the receptor tray and drain

through the accumulator drain hose. It is normal to see or hear a trickle of water either

during or immediately after ﬁlling. The accumulator is draining into the receptor tray.

Caulk the seam of wall and bath.

Cut template.

Mark bath profile line on drywall.

1128532-2-G 38 Kohler Co.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 155 156

No comments

Kohler K-1913-LW-47 Installation Guide Page 38