Kohler K-7303-KE-CP Installation Guide download pdf (Page 4)

2. Rigid Supply Tee Installation

Insert the plastic gasket and the rubber washer into the top of the

supply sleeve.

Slide the metal washer onto the spout shank.

Thread the shank nut up onto the spout approximately 1″ (2.5

cm).

Thread the supply tee to the spout shank until it is hand tight.

Tighten the hex-end of the supply tee with a wrench. Ensure that

the tubes are aligned to the sides. Do not overtighten.

Slide the metal washer down the shank to the rigid supply sleeve.

Thread the shank nut down to the washer. Securely tighten with

a wrench. Do not overtighten.

Spout

Shank

Nut

Plastic

Gasket

Tee Supply

Sleeve

Rubber

Washer

Tee Supply

Hex-End

Washer

117121-2-AB 4 Kohler Co.

1 2 3 4 5 6 7 8 9 ... 23 24

No comments

Kohler K-7303-KE-CP Installation Guide Page 4