Kohler K-7825-K-CP Installation Guide download pdf (Page 4)

3. Install the Supplies

NOTE: If the supply tubes need to be cut, allow for required

penetration of the tube into the supply stop.

NOTE: If the sink is not installed, install it at this time. Be sure to

follow all instructions packed with the sink.

Remove the burrs from all tubing cuts.

Slip the coupling nuts onto the supply tubes.

Position the round end of the supply tube (either ﬂared or

ferrule) squarely into the valve body inlet.

Hand tighten the coupling nuts.

Carefully bend the supply tubes to align them with the supply

stops.

Slide the coupling nuts and ferrules from the stops onto the

supply tubes.

Insert the supply tubes into the outlets of the shut-off valves.

Tighten the coupling nuts on the shut-off valves.

Turn on the water supply.

Valve

Body Inlet

Ferrule or

Flared End

Coupling

Nut

Supply Tube

Ferrule

Coupling Nut

Supply Tube

Supply Stop

Valve

Body Inlet

111058-2-AC 4 Kohler Co.

1 2 3 4 5 6 7 8 9 ... 15 16

No comments

Kohler K-7825-K-CP Installation Guide Page 4