Kohler K-4197-47 Installation Guide download pdf (Page 8)

Garantía (cont.)

limitaciones y exclusiones pueden no aplicar a su caso. Esta garantía le otorga ciertos

derechos legales especíﬁcos. Además, usted puede tener otros derechos que varían de

estado a estado y provincia a provincia.

El presente documento constituye la garantía exclusiva por escrito de Kohler Co.

Troubleshooting Guide

Symptoms Recommended Action

1. Poor ﬂush. A. Adjust the tank water level to match the waterline.

B. Fully open the water supply shut-off valve.

C. Clear obstructions from the trapway, jet, or bowl rim holes.

D. Clear obstructions from the waste line.

2. No ﬂush. A. Reconnect the chain to the trip lever or ﬂush valve.

B. Adjust the chain assembly to remove excessive slack.

3. The ﬁll valve

turns on/off

by itself

without the

toilet being

ﬂushed, or it

runs, allowing

water to enter

the tank.

A. Adjust the chain for proper slack so the seal is not held off the

ﬂush valve seat.

B. Clean or replace the seal if it is worn, dirty, or misaligned with

the ﬂush valve seat, or if the ﬂush valve seat is damaged.

Replace the ﬂush valve seal or ﬂush valve.

C. Clean the ﬁll valve seat and seat washer of debris, or replace

the piston/seat washer assembly.

D. Remove the tank and tighten the ﬂush valve nut if ﬂush valve

gasket is leaking. Do not overtighten. If leakage continues,

replace the gasket.

E. Adjust the tank water level if it is too high.

F. Replace the ﬁll valve if the valve ﬂoat sinks.

4. Tank takes

excessive time

to ﬁll.

A. Fully open the water supply shut-off valve.

B. Clean the valve inlet, valve head, or supply line. Flush the

lines.

5. There is

excessive noise

when the tank

is ﬁlling.

A. Partially close the water supply shut-off valve if the water

pressure to the toilet is too high. Check the toilet performance

following any such adjustment.

B. Remove dirt or obstructions from the valve head. Flush the

lines.

Guide de dépannage

Symptômes Action recommandée

1. Chasse faible. A. Régler le niveau d’eau du réservoir au niveau du repère.

B. Ouvrir complètement la valve d’arrêt d’alimentation.

C. Dégager toutes obstructions du siphon, du jet ou des trous du

rebord de la cuvette.

D. Dégager toute obstruction de la ligne d’évacuation.

2. Pas de chasse. A. Re-connecter la chaîne au levier de déclenchement ou à la

valve de chasse.

1142710-2-A 8 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Kohler K-4197-47 Installation Guide Page 8

Comments to this Manuals

Related products and manuals for Unknown Kohler K-4197-47