Kohler K-705729-L-SHP Installation Guide download pdf (Page 15)

10. Install the Door

NOTE: The door may require adjustment; do not make ﬁnal adjustments until the header and handle are

installed.

CAUTION: Risk of injury or product damage. Unframed tempered glass should not contact hard

surfaces or it may shatter. Do not touch the edge of the tempered glass panel with tools or any hard

objects. Do not set the unframed tempered glass directly on the ﬂoor.

IMPORTANT! Perform the following steps with two installers.

Place a bushing in the upper hole in the side lite glass panel where the top ﬁxed hinge will be

installed.

Place the gasket over the top corner of the side lite glass panel so that the hole in the gasket aligns

with the hole in the glass.

Installer #1

Lift the door into a position so that the hinge pin is above the ﬁxed hinge.

Carefully lower the door so the hinge pin ﬁts into the bottom hinge. Hold the door in place while

installer #2 installs the top ﬁxed hinge.

Installer #2

Place the top ﬁxed hinge over the gasket of the side lite glass panel and hinge pin.

Align the hole in the top ﬁxed hinge with the bushing and carefully position the top ﬁxed hinge on

pin.

Insert the large diameter screw through the bracket into the bushing and tighten until ﬂush with the

surface. Do not overtighten.

Top Fixed Hinge

Hinge Pin

Gasket

Bushing

Screw

Kohler Co. 15 1064866-2-C

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 59 60

No comments

Kohler K-705729-L-SHP Installation Guide Page 15