Kohler K-705810-L-ABV Installation Guide download pdf (Page 7)

4. Install the Wall Jambs and Threshold

Insert the ends of the threshold between the wall jambs with the lip toward the outside of the

shower.

Verify the threshold sits ﬂat on the shower ledge. Adjust the walls jambs and threshold as needed to

ensure the threshold runs parallel along the shower ledge.

Plumb both wall jambs using a level.

Using a pencil, mark the position of the bottom of both wall jambs on the shower ledge and on the

wall near the top of the wall jambs.

Mark the centers of the three wall jamb slots on the shower wall.

Remove the wall jambs and threshold.

Drill 5/16″ holes at the marked locations.

Thoroughly clean the shower ledge.

Insert wall anchors into the drilled holes.

IMPORTANT! If the ledge of your shower receptor is not ﬂat, you will need to shim the threshold so it is

installed ﬂat and level.

Using the marks as reference, reposition the threshold and wall jambs in the shower opening.

Secure the wall jambs to the shower wall using #8 x 1-1/4″ panhead screws.

Verify the wall jambs are plumb. Make adjustments as needed.

Apply silicone sealant at the intersection where each wall jamb meets the threshold.

Remove the labels from the wall jambs.

Mark center of

pre-drilled slots.

Tape jamb to

shower wall.

Threshold

Holes Face

Inside Shower

Lip

Level

Anchor

#8-32 x 1-1/4" Panhead Screw

Drill 5/16" holes.

Press and hold

legs together.

Kohler Co. 7 1144162-2-B

1 2 3 4 5 6 7 8 9 10 11 12 ... 59 60

No comments

Kohler K-705810-L-ABV Installation Guide Page 7