Kohler K-T16176-4-BN Installation Guide download pdf (Page 7)

3. Install the Trim

NOTE: If you are installing the K-T10422 trim, proceed to the

″Install the Trim - K-T10422″ section of this guide.

Firmly press the valve stem adapters onto each valve stem.

Secure the valve stem adapters to the valve with the correct

length screws, as selected in the ″Install the Valve Stem Adapters″

section of this guide.

Thread the two threaded studs into the threaded holes of the

valve.

Place the front plate assembly over the threaded studs.

NOTE: If the front plate assembly does not lay ﬂat on the wall

surface, loosen the nuts and adjust the threaded studs, then tighten

the nuts. The maximum distance between the threaded studs from

the wall is 7/16″ (1.11 cm).

Visually inspect the front plate assembly to ensure that the foam

seal is completely covering the wall opening. If not, stop the

installation and repair the wall opening.

Place the escutcheon against the wall. The drain hole in the

escutcheon should face downward in the 6 o’clock position.

Thread the handle assemblies onto the hubs of the front plate

assembly to secure the escutcheon in place. The volume control

handle assembly (top) should be at the 12 o’clock position. The

thermostatic valve handle assembly (bottom) should be at the 6

o’clock position.

Thermostatic Valve

Valve Stem Adapter

Finished Wall

Front Plate Assembly

Escutcheon

Screws

Threaded Studs

Nuts

Handle Assembly

Kohler Co. 7 1041504-2-F

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

No comments

Kohler K-T16176-4-BN Installation Guide Page 7