Kohler K-T309-4M-SN Installation Guide download pdf (Page 8)

5. Install the Handle

CAUTION: Risk of product damage to the K-306–KS valve

assembly. When using this valve in a ﬁberglass or acrylic

installation, use the Thin Wall Installation Kit (88526).

Remove the sleeve from the handle assembly.

Set the sleeve into the center of the shroud with the screw holes

aligned.

Secure the sleeve with two screws.

If you have a thin wall installation, remove the large and small

bearings from the long stem extension.

Reinstall the large and small bearing and washers onto the short

stem extension.

Secure the chosen stem extension into the handle assembly with a

screw.

Thread the handle assembly over the sleeve, and securely hand

tighten.

Sleeve

Screws

Screw

Short Stem Extension

Small Bearing

Large Bearing

Washers

Handle Assembly

Long Stem

Extension

1023642-2-C 8 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

No comments

Kohler K-T309-4M-SN Installation Guide Page 8