Kohler K-100-96 Installation Guide download pdf (Page 6)

Install the Bath (cont.)

NOTE: The illustration shown may not represent your actual

product. The installation instructions still apply.

For All Installations

With help, carefully move the bath into the installation area.

Connect the tailpiece of the drain to the trap.

Verify the bath is: (1) level across the top of the bath, (2) plumb

along the drain side, and (3) resting on all four feet. If the bath is

not level, metal shims must be placed under the bath feet.

Level the Bath

Turn the leveling bolts at the bottom of the four legs.

Recheck if the bath is: (1) level across the top of the bath, (2)

plumb along the drain side, and (3) resting on all four feet.

4. Install the Plumbing

CAUTION: Risk of property damage. A watertight seal

must exist on all bath drain connections. The watertight seal

will prevent property damage.

Connect the trap to the drain.

Install the faucet valving according to the faucet manufacturer’s

instructions. Do not install the faucet trim at this time.

Run water into the bath. Check the drain connections for leaks.

Fill the bath to the overﬂow. Check for leaks.

Install the faucet trim. Refer to the instructions packed with the

faucet trim.

Care and Cleaning

For best results, keep the following in mind when caring for your

KOHLER product:

•

Always test your cleaning solution on an inconspicuous area

before applying to the entire surface.

•

Wipe surfaces clean and rinse completely with water immediately

after applying cleaner. Rinse and dry any overspray that lands on

nearby surfaces.

•

Do not allow cleaners to soak on surfaces.

1084218-2-C 6 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

No comments

Kohler K-100-96 Installation Guide Page 6