Kohler K-1122-VBW-47 Installation Guide download pdf (Page 8)

6. Make Electrical Connections – Latin America

NOTE: The electrical rating of the product is printed on a label on the lumbar end of the bath. All

vibracoustic baths are designed to operate between 110 V and 240 V at either 50 Hz or 60 Hz.

WARNING: Risk of electric shock. Disconnect the power before performing the following

procedures.

WARNING: Risk of electric shock. Connect the bath to a properly grounded Ground-Fault

Circuit-Interrupter (GFCI) or Residual Current Device (RCD) for protection against line-to-ground

shock hazard.

IMPORTANT! The white wire should be connected to the load neutral terminal on the GFCI or RCD

breaker. The green wire is the equipment ground and must be connected to the neutral bus in the main

circuit breaker box.

Follow local electrical codes. Bond in accordance with national and local codes.

Remove the 120 V plug from the end of the electrical cord on the ampliﬁer.

Remove the 120 V plug from the electrical cord on the junction box mounted to the control board.

Connect service to the ampliﬁer with a 240 V plug (not included) or hardwire connection.

Connect service to the junction box with a 240 V plug (not included) or hardwire connection.

Junction

Box

Black

(L1)

Wire Connector

Green

(Ground)

From Control

White

(Neutral)

Provide suitable strain relief.

*Connections at the Circuit Breaker

Typical 240 V Wiring Connection

Field Wiring

(From Junction Box

to Breaker Box)

Equipment Ground*

Line Neutral

(White Curly Wire)*

Neutral

Bus

240 V

Typical Single-Pole

Circuit Breaker

with GFCI

Breaker Box

L1N

240 VAC Source

Bond in accordance with national and local codes.

Load Neutral

1212240-2-B 8 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 59 60

Comments to this Manuals

No comments

Kohler K-1122-VBW-47 Installation Guide Page 8

Comments to this Manuals

Related products and manuals for Unknown Kohler K-1122-VBW-47