Kohler K-14431-3-CP Installation Guide download pdf (Page 10)

6. Secure the Handles

Thread the screws (provided) into the ring. The screws should extend 1/8″ (3 mm)

from the ring.

If the mounting surface thickness is less than 5/8″ (1.6 cm), install a dished

washer, metal washer, and ring.

If the mounting surface thickness is 5/8″ (1.6 cm) or greater, install a metal washer

and ring.

Install the metal washer and ring onto each valve body. Thread the ring until it

stops and back it off 1/8″ (3 mm).

Rotate each valve body until the copper tubing faces toward the outside of the

bidet.

Hold the handles in place and tighten the screws on each ring until each valve is

ﬁrmly secured.

Remove any excess putty or sealant.

Fixation des poignées

Visser les vis (fournies) sur l’anneau. Les vis doivent dépasser de 1/8″ (3 mm)

l’anneau.

Si l’épaisseur de la surface de montage est inférieure à 5/8″ (1,6 cm), installer une

rondelle bombée, une rondelle en métal, et l’anneau.

Si l’épaisseur de la surface de montage est de 5/8″ (1,6 cm) ou plus, installer une

rondelle en métal, et l’anneau.

Dished Washer

Rondelle bombe

Arandela cóncava

Screw

Vis

Tornillo

Ring

Anneau

Anillo

Ring

Anneau

Anillo

Metal Washer

Rondelle métallique

Arandela de metal

5/8" (1.6 cm) or greater.

5/8" (1,6 cm) ou supérieur.

5/8" (1,6 cm) o mayor.

Less than 5/8" (1.6 cm).

Moins de 5/8" (1,6 cm).

Menos de 5/8" (1,6 cm).

1144569-2-A 10 Kohler Co.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Comments to this Manuals

No comments

Kohler K-14431-3-CP Installation Guide Page 10

Comments to this Manuals

Related products and manuals for Unknown Kohler K-14431-3-CP