Kohler K-1954-0 Installation Guide download pdf (Page 4)

1. Remove the Handle

Touchless Only Conﬁgurations (recommended)

IMPORTANT! Do not install the batteries until instructed. The

sensor will activate when the batteries are installed, making it

difficult to complete the installation process.

NOTE: The steps in this section are recommended, but are optional

for most installations. If your installation will retain the handle, go

to the ″Determine the Bracket Location″ section.

Remove the Handle Components

Turn off the water supply to the toilet.

Flush the toilet to remove most of the water from the tank.

Disconnect the chain from the handle.

If the tank has a canister (shown), reattach the chain to itself near

the canister attachment point.

Remove the handle assembly (the nut on the handle assembly

will most likely loosen clockwise).

IMPORTANT! If your model of toilet has a ﬂoat attached to the

handle chain, the ﬂoat must not be removed. The ﬂoat is critical for

proper ﬂushing performance.

Install the Handle Hole Cover

Chain

Hole Cover

Nut

Flush Valve

Handle

Fill Valve

1216369-2-D 4 Kohler Co.

1 2 3 4 5 6 7 8 9 ... 63 64

No comments

Kohler K-1954-0 Installation Guide Page 4