Kohler K-7213-AF Installation Guide download pdf (Page 8)

Ensamble el codo del rebosadero

Coloque las cuatro lengüetas del empaque colocado sobre la lengüeta exterior del

codo del rebosadero.

File el empaque en el codo del rebosadero.

Alinee el codo del rebosadero con la salida del rebosadero.

Coloque el lado cónico de la rejilla al ras contra la salida del rebosadero.

Apriete a mano el retén en el cilindro. No apriete con la llave en este momento.

Veriﬁque que el codo del rebosadero esté en la posición vertical. Si es necesario,

aﬂoje la tuerca para ajustar el codo del rebosadero.

3. Secure Fittings

NOTE: The same steps apply to both the through-the-ﬂoor and above-the-ﬂoor

installations, but the tee is aligned differently. Refer to the illustration for proper

alignment of the tee.

Properly align the tee for your particular installation, then align the overﬂow ell

and drain ell with the tee. Refer to the illustration for proper tee alignment.

NOTICE: The PVC tubes must be seated approximately 1” (2.5 cm) into the tee,

overﬂow ell, and drain ell. This will ensure a watertight seal.

Dry ﬁt the PVC tubing approximately 1″ (2.5 cm) into the tee, overﬂow ell, and

drain ell.

If necessary, mark the PVC tubes to obtain proper ﬁt with your bath.

Remove the PVC tubes, tee, overﬂow ell, and drain ell.

Overflow Ell

Coude de trop-plein

Codo de rebosadero

PVC Tubing

Tuyauterie PVC

Tubo de PVC

PVC Tubing

Tuyauterie PVC

Tubo de PVC

Drain Ell

Coude de drain

Codo de desagüe

Through-the-Floor Installations

Installations à travers le sol

Instalaciones a través del piso

Tee/T/T

Tailpiece

Pièce de raccordement

Tubo final

Tailpiece

Pièce de raccordement

Tubo final

Above-the-Floor Installations

Installations au-dessus du sol

Instalaciones sobre el nivel del piso

1108247-2-A 8 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Kohler K-7213-AF Installation Guide Page 8

Comments to this Manuals

Related products and manuals for Unknown Kohler K-7213-AF