Kohler COMMAND CH18-745 User Manual download pdf (Page 151)

8.34

Section 8

Electrical System and Components

Figure 8-58. Installing Thrust Washer.

4. Apply a small amount of oil to the bearing in the

drive end cap, and install the armature with the

drive pinion.

5. Lubricate the fork end and center pivot of the

drive lever with drive lubricant (Kohler Part No.

52 357 02-S). Position the fork end into the space

between the captured washer and the rear of the

pinion.

6. Slide the armature into the drive end cap, and at

the same time seat the drive lever into the

housing.

NOTE: Correctly installed, the center pivot section of

the drive lever will be flush or below the

machined surface of the housing which

receives the backup washer. See Figure 8-59.

Figure 8-59. Installing Armature and Pivot Lever.

Figure 8-60. Installing Backup Washer and

Grommet.

8. Install the frame, with the small notch forward,

onto the armature and drive end cap. Align the

notch with the corresponding section in the rubber

grommet. Install the drain tube in the rear cutout,

if it was removed previously. See Figure 8-61.

7. Install the backup washer, followed by the rubber

grommet, into the matching recess of the drive

end cap. The molded recesses in the grommet

should be “out”, matching and aligned with those

in the end cap. See Figure 8-60.

Figure 8-61. Installing Frame and Drain Tube.

9. Install the flat thrust washer onto the commutator

end of the armature shaft. See Figure 8-62.

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 217 218

No comments

Kohler COMMAND CH18-745 User Manual Page 151