Kohler COMMAND CH18-745 User Manual download pdf (Page 187)

11.2

Section 11

Reassembly

Figure 11-2. Installing Oil Seal.

Install Governor Cross Shaft

1. Lubricate the governor cross shaft bearing

surfaces in the crankcase with engine oil.

2. Slide the small lower washer onto the governor

cross shaft and install the cross shaft from the

inside of the crankcase.

3. 6 mm Governor Shaft: Install the plain washer

and then insert the hitch pin into the smaller, lower

hole of the governor cross shaft. See Figures 11-3

and 11-4.

8 mm Governor Shaft: Install the nylon washer

onto the governor cross shaft, then start the push-

on retaining ring. Hold the cross shaft up in

position, place a 0.50 mm (0.020 in.) feeler gauge

on top of the nylon washer, and push the retaining

ring down the shaft to secure. Remove the feeler

gauge, which will have established the proper end

play. See Figures 11-5 and 11-6.

Figure 11-4. Installing Governor Cross Shaft Hitch

Pin (6 mm Shaft).

Figure 11-3. Installing 6 mm Governor Cross Shaft.

Figure 11-6. Setting Governor Cross Shaft End Play

(8 mm Shaft).

Install Crankshaft

1. Carefully slide the flywheel end of the crankshaft

through the main bearing in the crankcase. See

Figure 11-7.

Figure 11-5. Installing 8 mm Governor Cross Shaft.

1 2 ... 182 183 184 185 186 187 188 189 190 191 192 ... 217 218

No comments

Kohler COMMAND CH18-745 User Manual Page 187