Kohler COMMAND CH18-745 User Manual download pdf (Page 193)

11.8

Section 11

Reassembly

Install Flywheel

WARNING: Damaging Crankshaft and

Flywheel Can Cause Personal Injury!

Using improper procedures to install the flywheel can

crack or damage the crankshaft and/or flywheel. This

not only causes extensive engine damage, but can

also cause personal injury, since broken fragments

could be thrown from the engine. Always observe and

use the following precautions and procedures when

installing the flywheel.

NOTE: Before installing the flywheel make sure the

crankshaft taper and the flywheel hub are

clean, dry, and completely free of any

lubricants. The presence of lubricants can

cause the flywheel to be over stressed and

damaged when the hex. flange screw is

torqued to specifications.

Figure 11-23. Torquing Stator Screws.

4. Route the stator leads in the crankcase channel,

then install the backing plates and the stator wire

bracket (if used). Secure using the four hex.

flange screws. See Figures 11-24 and 11-25.

Torque the screws to 7.3 N·m (65 in. lb.).

Figure 11-24. Route Stator Leads in Groove.

Figure 11-26. Clean and Dry Taper of Crankshaft.

Figure 11-25. Installing Backing Plates and Stator

Wire Bracket.

Figure 11-27. Clean and Dry Flywheel Hub.

1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 217 218

No comments

Kohler COMMAND CH18-745 User Manual Page 193