Kohler COMMAND CH18-745 User Manual download pdf (Page 153)

8.36

Section 8

Electrical System and Components

Figure 8-66. Installing Brush Holder Assembly

using Tool with Extension.

11. Install the end cap onto the armature and frame,

aligning the thin raised rib in the end cap with the

corresponding slot in the grommet of the positive

(+) brush lead.

12. Install the two thru bolts, and the two brush holder

mounting screws. Torque the thru bolts to

5.6-9.0 N·m (49-79 in. lb.). Torque the brush

holder mounting screws to 2.5-3.3 N·m

(22-29 in. lb.). See Figures 8-67 and 8-68.

Figure 8-67. Torquing Thru Bolts.

Figure 8-68. Torquing Brush Holder Screws.

13. Hook the plunger behind the upper end of the

drive lever, and install the spring into the solenoid.

Insert the three mounting screws through the

holes in the drive end cap. Use these to hold the

solenoid gasket in position, then mount the

solenoid. Torque the screws to 4.0-6.0 N·m

(35-53 in. lb.).

14. Connect the positive (+) brush lead/bracket to the

solenoid and secure with the hex. nut. Torque the

nut to 8-11 N·m (71-97 in. lb.). Do not

overtighten. See Figure 8-69.

Figure 8-69. Positive (+) Brush Lead Connection.

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 217 218

No comments

Kohler COMMAND CH18-745 User Manual Page 153