Kohler COMMAND CH18-745 User Manual download pdf (Page 160)

9.7

Section 9

Disassembly

3. Remove the carburetor, throttle linkage and

governor lever as an assembly. See Figure 9-24.

Figure 9-26. Removing Electric Starter Motor.

3. Remove the starter assembly and any spacers (if

used).

Remove Outer Baffles and Blower Housing

1. Disconnect the plug from the rectifier-regulator on

the blower housing. See Figure 9-27.

Remove Electric Starter Motor

1. Disconnect the leads from the starter.

2. Remove the two hex. flange screws. See Figure

9-26.

Figure 9-24. Removing Carburetor Assembly with

Governor Lever Attached.

4. Remove the carburetor gasket.

5. If necessary, the carburetor, throttle linkage and

governor lever can be separated. Reattach the

bushings to the linkage following separation to

avoid losing them.

Remove Oil Sentry

™

(If So Equipped)

1. Disconnect the lead from the Oil Sentry

™

switch.

2. Remove the Oil Sentry

™

switch from the breather

cover. See Figure 9-25.

Figure 9-25. Removing Oil Sentry

™

Switch from

Breather Cover.

Figure 9-27. Disconnecting Plug from Rectifier-

Regulator.

2. Use the tip of the dipstick or a similar small flat

tool to bend the locking tang, then remove the B+

(center lead) from the terminal plug as shown in

Figure 9-28. This will allow the blower housing to

be removed without disturbing the wiring harness.

1 2 ... 155 156 157 158 159 160 161 162 163 164 165 ... 217 218

Comments to this Manuals

No comments

Kohler COMMAND CH18-745 User Manual Page 160

Comments to this Manuals

Related products and manuals for For the car Kohler COMMAND CH18-745