Kohler K-4709-0 Installation Guide download pdf (Page 9)

6. Install the Remote Holder

Choose a mounting location for the remote holder that is easily

accessible while sitting on the seat.

The remote holder can be installed using screws or double-sided

tape. Choose your preferred method for securing the remote

holder. Follow only the instructions for your chosen installation

method.

Install Using Screws

NOTE: Anchors may not be needed for installation to certain

materials. Use the appropriate mounting hardware for your

particular installation surface.

Position the remote holder at the desired mounting location with

the rectangular indent toward the bottom (as shown).

Using a pencil, mark the two mounting hole locations. Set the

holder aside.

For installation to stud or other wood surface: Drill a 1/16″ hole

at each of the marked locations.

For installation using wall anchors: Drill a 1/4″ hole at each of

the marked locations. Install the wall anchors into the holes.

Position the remote holder over the mounting holes so the

rectangular indent is toward the bottom.

Secure the remote holder with the screws.

Remote Holder

If used, apply tape here.

Anchors

Screws

Remote

Covers

Kohler Co. 9 1054180-2-E

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

No comments

Kohler K-4709-0 Installation Guide Page 9