Kohler K-1110-AH-0 Installation Guide download pdf (Page 13)

14. Conﬁrm Proper Operation

Fill the Whirlpool

NOTE: Please read these steps carefully before you operate your whirlpool.

Turn the jet trim rings fully counterclockwise. Position the jet nozzles so they face down toward the

basin.

Fill the whirlpool until the water level sensors (if equipped) are submerged. If your whirlpool does

not have sensors, ﬁll the whirlpool to a level at least 2″ (5.1 cm) above the highest jet.

NOTE: The water temperature in the whirlpool should not exceed 104°F (40°C). The heater will

automatically turn off as the water temperature approaches 104°F (40°C) and will remain off until the

water cools.

15. Operating Sequence

NOTE: A built-in heater automatically helps to maintain the water temperature when the whirlpool is

running, as long as the water temperature does not exceed 104°F (40°C). The heater will disengage at

higher temperatures.

IMPORTANT! Please refer to your Homeowners Guide for detailed instructions on the user keypad and

optional remote control.

NOTE: The keypad above shows features for all models. Your keypad may vary based on your whirlpool

model.

Press the Power On/Off button to turn on the whirlpool. The whirlpool will start at medium ﬂow.

Increase or decrease the water ﬂow by pressing either the up or down arrow buttons on the keypad.

An indicator bar in the center of the keypad shows the water ﬂow volume.

Adjust each jet for optimum air/water mixture. Turn the jet trim clockwise to reduce the air ﬂow,

and counterclockwise to increase the air ﬂow.

Rotate the outer ring until the heater button is ﬂashing. Press ″OK″ to turn the heater off. Press

″OK″ again to turn the heater back on. The heater will help to maintain the water temperature up to

104°F (40°C).

Press the Power On/Off button a second time to turn the whirlpool off.

NOTE: A built-in timer automatically stops the pump and motor after approximately 20 minutes of

operation.

Activates Mode

Selected

Indicator Bar - Shows water

flow volume or pulse rate

Turn the jet trim

clockwise to

decrease the flow.

Turn the jet trim

counterclockwise to

increase the flow.

Power On/Off

Neckjet Mode -

Adjust Pulse

Backjet Mode -

Adjust Pulse

Chromatherapy -

Specific Color

Rotate outer

ring to access

desired mode.

Chromatherapy Cycle

Heater On/Off

Lighted User Keypad

Decreases Flow or Pulse

Effervescence Mode

Increases Flow or Pulse

Flexjet Flow Mode

Kohler Co. 13 1022365-2-C

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 59 60

Comments to this Manuals

No comments

Kohler K-1110-AH-0 Installation Guide Page 13

Comments to this Manuals

Related products and manuals for Unknown Kohler K-1110-AH-0