Kohler K-1357-VB-0 Installation Guide download pdf (Page 4)

Roughing-In - Required Components

For best results, follow the suggested installation sequence below. Speciﬁc, detailed instructions for each

installation step are located on the remaining pages of this installation guide.

NOTE: The illustration above shows a typical installation with the preferred installation locations for the

user interface and control ampliﬁer.

Suggested Installation Sequence

Determine the installation location for the bath, user interface, and control ampliﬁer.

NOTICE: Use wood stud or concrete framing for the bath frame. Metal framing may adversely affect the

vibracoustic quality of the product.

Determine the location for the access panel (required) for servicing the control ampliﬁer.

Construct the island or drop-in framing for the bath.

Install the deck material.

Route all plumbing supply lines for the bath.

Install the bath and drain.

Route the transducer cables to the area chosen for the control ampliﬁer.

If equipped, route the optional chromatherapy cable to the area chosen for the control ampliﬁer.

Route the user interface cable from the control ampliﬁer area to the user interface location.

Install an electrical outlet within 24″ (610 mm) of the area chosen for the control ampliﬁer.

Install the control ampliﬁer.

Connect the transducer, user interface, optional auxiliary device, and chromatherapy cables (if

equipped) to the control ampliﬁer.

Finish the walls and deck, and install the required access panel for the control ampliﬁer.

Connect the user interface cable to the user interface, and install the user interface.

User Interface

10"

(254 mm)

24" (610 mm)

Transducer

Wires

Chromatherapy

Wire (If

Equipped)

6" (152 mm) Maximum

Access

Panel

Control

Amplifier

1181167-2-E 4 Kohler Co.

1 2 3 4 5 6 7 8 9 ... 55 56

No comments

Kohler K-1357-VB-0 Installation Guide Page 4