Kohler K-16238-4-SN Installation Guide download pdf (Page 15)

9. Connect the Supplies

Connect the supply tubes to the valve inlets and then to the shut-off valves. Left is

hot and right is cold.

Tighten all connections.

Raccordement des alimentations

Connecter les tuyaux d’alimentation aux entrées du robinet, puis aux robinets de

sectionnement. Chaud à gauche et froid à droite.

Serrer toutes les connexions.

Conecte los suministros

Conecte los tubos de suministro a las entradas de la válvula y luego a las llaves

de paso. El lado izquierdo corresponde al agua caliente, y el derecho, al agua fría.

Apriete todas las conexiones.

10. Complete the Installation

Connect the tailpiece and P-trap (as needed).

Ensure that all connections are tight.

Open the drain.

Turn on the main water supply and check for leaks. Adjust as needed.

Turn the spray assembly down.

Open both hot and cold valves and run water for about a minute to remove

debris. Check for leaks.

Turn the faucet off.

Valve Inlet

Entrée de valve

Entrada de la válvula

Supply Tube

Tuyau d'alimentation

Tubo de suministro

Shut-off Valve

Arrêt d'alimentation

Llave de paso

Supply Tube

Tuyau d'alimentation

Tubo de suministro

Valve Inlet

Entrée de valve

Entrada de la válvula

Kohler Co. 15 1138801-2-A

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

No comments

Kohler K-16238-4-SN Installation Guide Page 15