Kohler K-2592-W1-NY Installation Guide download pdf (Page 6)

4. Install the Bath

Apply a generous amount of silicone sealant to the support blocks on the base of the shroud.

Apply sealant to both sides of the gaskets on the drain and overﬂow assembly.

NOTE: To provide access for securing the faucet connections, temporarily position block spacers at the

corners between the shroud and the bath rim. Position the blocks to avoid damaging the alignment guides

located under the bath rim.

With help, carefully lift the bath into place over the shroud and onto the block spacers.

Secure all faucet connections and ﬁttings.

Carefully remove the blocks and make sure the bath rim engages the top of the shroud on all sides.

Install the drain ﬂange and overﬂow cover according to the drain instructions.

Close the bath drain. Fill the bath to the overﬂow, and check for leaks.

If desired, apply a thin, continuous bead of clear or color-matched silicone sealant to the seam

between the shroud and the ﬁnished ﬂoor.

Care and Cleaning

For best results, keep the following in mind when caring for your KOHLER product:

•

Always test your cleaning solution on an inconspicuous area before applying to the entire surface.

•

Wipe surfaces clean and rinse completely with water immediately after applying cleaner. Rinse and

dry any overspray that lands on nearby surfaces.

•

Do not allow cleaners to soak on surfaces.

•

Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring

pad to clean surfaces.

For detailed cleaning information and products to consider, visit www.kohler.com/clean. To order Care &

Cleaning information, call 1-800-456-4537.

Apply silicone

sealant.

Temporary

Blocks

Alignment

Guide

1237787-2-B 6 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

No comments

Kohler K-2592-W1-NY Installation Guide Page 6