Kohler K-2595-G-47 Installation Guide download pdf (Page 3)

Tools and Materials

Before You Begin

NOTICE: Adequate ﬂoor support must be provided. Note the model number on the components end of

the bath, then visit the product page at www.kohler.com for additional information.

NOTICE: Do not support the load weight of the bath by the rim.

NOTICE: Before installing a rim-mount bath faucet, refer to the speciﬁcation sheet on the product page at

www.kohler.com.

NOTICE: For remote blower installations, refer to the installation instructions included with the remote

blower installation kit K-1446 before proceeding.

Observe all local plumbing and building codes.

Unpack and inspect the bath and components for damage. Return the bath and components to the

carton until installation.

To simplify future maintenance, make sure all plumbing and control board connections around the

bath are easily accessible.

Use conduit to route electrical wires from the circuit breaker.

Carefully plan moving the bath into the installation area. This bath will not easily ﬁt through

doorways.

Two people are needed to install this product.

Install the bath to an adequately supported, level ﬁnished ﬂoor.

This bath is designed for freestanding installation only.

If installing a rim-mount faucet, make sure there is no interference with the drain overﬂow before

drilling any holes. Consult local and national codes for minimum air gap requirements if installing a

spout on the rim.

Illustrations shown may not look like your actual product but they still apply for this installation.

This bath conforms to CSA B45.5/IAPMO Z124. All dimensions are nominal.

Safety Glasses PencilTape Measure

Silicone Sealant Level

Plus:

• Drop Cloth

• Shims

• Short Ø 1-1/2" PVC Pipe or Coupling

• 2x4

• Wood Blocks

Silicone Adhesive

Kohler Co. 3 1237791-2-B

1 2 3 4 5 6 7 8 ... 43 44

No comments

Kohler K-2595-G-47 Installation Guide Page 3