Kohler K-5702-VB-G9 Installation Guide download pdf (Page 4)

Plan the Installation

For best results, follow the installation sequence below. Detailed instructions are found on the following

pages of this guide.

Recommended Installation Sequence

Determine the locations for the bath components. Refer to the illustration for preferred locations.

Plan the required access panel location for servicing the control ampliﬁer.

Route plumbing supply lines.

Prepare the bath rim, if using a rim-mount faucet.

Mark and install the drain pipe.

Install the bath shroud.

Bind all cables in preparation for the bath installation.

Install an electrical outlet within 24″ (610 mm) of the control ampliﬁer location.

Install the bath and drain. Route the bound cables through the bottom of the shroud.

Route the transducer wires to the control ampliﬁer location.

If equipped, route the chromatherapy cable to the control ampliﬁer location.

Connect the transducer wires, user interface cable, optional auxiliary cable, and chromatherapy cable

(if equipped) to the control ampliﬁer.

Route the user interface cable to the user interface location.

Install the control ampliﬁer.

Install the access panel for the control ampliﬁer.

Connect the user interface cable to the user interface, and install the interface.

Connect the control ampliﬁer to the electrical outlet.

Test the functionality of all bath components. Refer to the ″Homeowners Guide″ for operation.

Transducer Wires

User Interface

Cable

Chromatherapy

Cable (Some Models)

Optional Auxiliary-In

Cable

Transducer

Ethernet Connector

1237789-2-C 4 Kohler Co.

1 2 3 4 5 6 7 8 9 ... 59 60

No comments

Kohler K-5702-VB-G9 Installation Guide Page 4