Kohler K-737-K-NA Installation Guide download pdf (Page 5)

3. Two-Way Installation

IMPORTANT! This valve is not intended to be used as a shut-off

valve. Do not plug any outlets without completing the two-way

conversion.

Two-Way Conversion

Temporarily remove the plaster guard.

Rotate the detent until positioned vertically, as illustrated.

Verify the missing tooth is oriented up.

IMPORTANT! If the internal plug is not removed, the ﬁnished wall

will need to be removed to perform this step at a later date.

Using a 1/4″ hex wrench, remove and discard the internal plug

from inside the valve body.

Plug the unused port (left or right) with a 1/2″ NPT plug (not

included).

Using a pliers, remove the spacer from beneath the detent.

Push the detent in; ensure the points of the detent engage the

notches of the valve cartridge.

Install the spacer above the detent and under the E-ring.

Install the Two-Way Valve

Install 1/2″ copper tubing or piping for both accessories. Securely

fasten the piping and outlet ells to the framing.

Accessory #1

Water Line

Accessory #2

Water Line

Spacer

1/2"

NPT Plug

E-Ring

Plaster

Guard

Detent

Missing Tooth

Internal

Plug

Kohler Co. 5 1205548-2-B

1 2 3 4 5 6 7 8 9 10 ... 23 24

No comments

Kohler K-737-K-NA Installation Guide Page 5