Kohler K-852-HB-0 Installation Guide download pdf (Page 14)

16. Conﬁrm Proper Operation

Fill the Whirlpool

NOTE: Please read these steps carefully before you operate your whirlpool.

Position the jet nozzles so they face down toward the basin. Turn the jet trim rings fully

counterclockwise.

Fill the whirlpool to a water level at least 2″ (5.1 cm) above the top of the highest jet.

NOTE: The water temperature in the whirlpool should not exceed 104°F (40°C). The heater will

automatically turn off as the water temperature approaches 104°F (40°C) and will remain off until the

water cools.

17. Operating Sequence

NOTE: A built-in heater automatically helps to maintain the water temperature when the whirlpool is

running, as long as the water temperature does not exceed 104°F (40°C). The heater will disengage at

higher temperatures.

IMPORTANT! Please refer to your Homeowners Guide for detailed instructions on the user keypad and

optional remote control.

Press the Power On/Off button to turn on the whirlpool. The whirlpool will start at medium ﬂow.

Increase or decrease the water ﬂow by pressing either the up or down arrow buttons on the keypad.

An indicator bar in the center of the keypad shows the water ﬂow volume.

Adjust each jet for optimum air/water mixture. Turn the jet trim clockwise to reduce the air ﬂow,

and counterclockwise to increase the air ﬂow.

Press the heater button to turn the heater off and back on. When illuminated, the indicator light

shows that the water temperature will be maintained up to 104°F (40°C).

Press the Power On/Off button a second time to turn the whirlpool off.

NOTE: A built-in timer automatically stops the pump and motor after approximately 20 minutes of

operation.

18. Troubleshooting Procedures

This troubleshooting guide is for general aid only. A Kohler Authorized Service Representative or qualiﬁed

electrician should correct all electrical problems. For warranty service, contact your dealer or wholesale

distributor.

Indicator Bar -

Shows water

flow volume

Power On/Off

Heater On/Off

Heater Indicator Light

Increases Flow

Decreases Flow

Lighted User Keypad

Turn the jet trim

clockwise to

decrease the flow.

Turn the jet trim

counterclockwise to

increase the flow.

1019436-2-F 14 Kohler Co.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 51 52

Comments to this Manuals

No comments

Kohler K-852-HB-0 Installation Guide Page 14

Comments to this Manuals

Related products and manuals for Unknown Kohler K-852-HB-0