Kohler K-15592-5P-CP Installation Guide download pdf (Page 5)

3. Complete Pop-Up Drain Installation

IMPORTANT! If the tailpiece has been removed, double check that

the plastic washer is installed inside the ﬂange body or the drain

will leak.

Connect the P-trap to the tailpiece.

Press the seal into the lift rod hole on the body.

Insert the stopper into the ﬂange.

For regular installations, insert the short end of the rod into the

lift rod hole and under the stopper rod. For vandal-resistant

installations, ﬁt the rod through the hole in the stopper rod.

Hand tighten the rod nut.

Remove and adjust the stopper as needed so it lifts about 3/8″ (1

cm) when opened. To adjust, rotate the threaded stopper rod in or

out as needed. Retighten the stopper nut.

Slide one end of the clip onto the rod. Slide the link onto the lift

rod with the thumbscrew facing the back of the ﬁxture.

Squeeze the other end of the clip, aligning the hole with the rod.

Move the link to the proper position by squeezing the clip and

sliding it along the rod.

Insert the lift rod into the hole in the body and then into the hole

in the link.

Tighten the thumbscrew onto the link so the lift rod knob extends

1/2″ (1.3 cm) above the lift rod hole.

Check for leaks.

Body

Clip

Stopper

Flange

Seal

Rod Nut

Tailpiece

Thumb

Screw

Stopper

Rod

Plastic

Washer

Link

Rod

Kohler Co. 5 1010442-2-D

1 2 3 4 5 6 7 8 9 10 ... 27 28

No comments

Kohler K-15592-5P-CP Installation Guide Page 5