Kohler K-171-PB Installation Guide download pdf (Page 4)

2. Install the Faucet

NOTE: A rubber washer is located in the depression in the round

base.

Slip the round base over the tubing and to the faucet base.

Fit the faucet through the sink hole.

Position the faucet so the spray inlet is toward the back.

Partially thread the screws into the ring until they barely protrude

from the backside of the ring.

Slide the ﬁber washer and metal washer on the threaded shank.

Thread the ring to the threaded shank until it is about 1/4 turn

from touching the sink bottom.

Turn the ring so the screws are to the front and back of the

faucet.

Tighten the screws using a Phillips screwdriver.

Fiber

Washer

Threaded Shank

Tubing

Metal Washer

Screws

Ring

Spray Inlet

Round Base

Faucet Base

1015073-2-E 4 Kohler Co.

1 2 3 4 5 6 7 8 9 ... 19 20

No comments

Kohler K-171-PB Installation Guide Page 4