Kohler K-2362-4-58 Installation Guide download pdf (Page 5)

1. Preparation

Install sufficient backing behind the ﬁnished wall to provide adequate support to

secure the mounting hardware.

Install the water supplies and drain piping according to the roughing-in

information. Ensure the supply stop handles will not make contact with the

pedestal when the supplies are fully open.

Apply six self-adhesive gaskets (provided) to the underside of the basin.

Mark the centerline location on the ﬂoor; refer to the ″Roughing-In″ section.

Position the pedestal on the marked centerline.

IMPORTANT! The lavatory basin must be supported by the pedestal.

Carefully lift the basin and position it on the pedestal.

Verify the basin is properly supported by the pedestal.

Slowly move the pedestal as needed until the basin is positioned against the wall

at the installation location.

Level the basin by adding additional self-adhesive gaskets as needed.

CAUTION: Risk of personal injury. Product can break, chip, or cause injury if

handled carelessly. Have someone hold the basin while you mark the mounting

hole locations.

Locate the two basin mounting holes; mark their locations onto the wall.

Mark the pedestal hole location onto the ﬂoor.

Carefully remove the basin from the pedestal and remove both the basin and

pedestal from the installation area.

Install backing.

Installer de renfort.

Instale del refuerzo.

Centerline

Ligne centrale

Línea central

Apply adhesive gaskets.

Appliquer des joints adhésifs.

Aplique los empaques adhesivos.

Underside of Basin

Base du bassin

Parte inferior del lavabo

Pedestal

Colonne

Pedestal

Mark floor here.

Marquer le sol ici.

Marque el piso aquí.

Finished Wall

Mur fini

Pared acabada

Basin

Bassin

Lavabo

Kohler Co. 5 1087254-2-B

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Kohler K-2362-4-58 Installation Guide Page 5

Comments to this Manuals

Related products and manuals for Sanitary ware Kohler K-2362-4-58