Kohler K-6330-CP Installation Guide download pdf (Page 3)

1. Supply Installation

NOTE: This spout and valve can be installed from 4″ (10.2 cm) to 8″

(20.3 cm) between center-to-center.

NOTE: The water supply lines must be offset to the right or left as

shown to avoid interference with the pulley cover.

Install the water supplies and drain line according to the

illustration.

Flush the water supplies and stops.

2. Faucet Installation

Install the rubber gasket to the underside of the valve.

Fit the valve through the desired sink hole.

Position the valve so the handle faces forward.

Thread two screws into the threaded ring until they barely

protrude from the top of the threaded ring.

Fit the ﬁber washer and metal washer to the valve shank.

Install the threaded ring to the valve shank until the threaded

ring is just touching the sink.

Turn the threaded ring so the screws are to the front and back of

the faucet.

Securely tighten the screws.

Install valve to

right or left of

spout.

Pulley Cover

Drain Line

Water

Supplies

Valve

Inlet

Sink

Screw

Valve

Shank

Rubber

Gasket

Fiber Washer

Threaded Ring

Metal Washer

Kohler Co. 3 1025493-2-B

1 2 3 4 5 6 7 8 ... 31 32

No comments

Kohler K-6330-CP Installation Guide Page 3