Kohler K-1188-RE-0 Installation Guide download pdf (Page 17)

Using Your Bath (cont.)

As the pump/motor turns on and water begins to circulate, the light will change to solid green, and

will stay on as long as the overﬂowing bath is running.

Verify that the indicator light for the heater is on when the overﬂowing bath is in operation. This

indicator light is located on the underside of the heater box, and is near the subﬂoor at the pump

end of overﬂowing bath. If the light is not on when the overﬂowing bath is running, press the reset

button located to the right of the indicator light on the heater box.

Press the ″On/Off″ control switch again to turn off the overﬂowing bath. The orange light in the

″On/Off″ switch will temporarily turn on to indicate the end of the operating mode. The green light

in the ″On/Off″ control switch will then start to blink automatically until the overﬂowing bath is

drained below the overﬂow channel sensors or restarted.

NOTE: A built-in timer automatically stops the bath after approximately 20 minutes of operation.

16. Chromatherapy Light Operation (if equipped)

NOTE: These directions pertain to the use of the mounted control pad only. For more information, see the

″Test the Remote Control″ section.

If the chromatherapy lights are turned off, press the button on the control pad (located on the opposite side

of the overﬂowing bath. The chromatherapy lights will begin to cycle through each of the colors (sweep

mode).

When the chromatherapy lights are in sweep mode, you can lock in one color light by pressing the control

button.

When an individual color is locked in, press the control button to turn the chromatherapy lights off.

Troubleshooting Procedures

Troubleshooting Table

This Troubleshooting Guide is for general aid only. Contact a Kohler Authorized Service Representative or a

qualiﬁed electrician to correct all electrical problems. For warranty service, contact your dealer or wholesale

distributor.

Symptoms Probable Causes Recommended Action

1. Green light in

“On/Off” control

switch ﬂashes before

the bathing well is

full of water.

A. Spout ﬁlls directly into

overﬂow channel.

A. Adjust/reinstall the spout

to ﬁll directly into the

bathing well. Refer to the

installer/dealer.

B. One or both butterﬂy

valves do not work.

B. Check the butterﬂy valve

wiring or replace the

butterﬂy valves. Refer to

the installer/dealer.

C. Control does not work. C. Check the wiring or

replace the control. Refer

to the installer/dealer.

2. Product does not

start.

A. No power to unit. A. Turn on the power to the

unit, or correct the source

of the power loss. Refer to

the installer/dealer.

Kohler Co. 17 1019731-2-C

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 63 64

Comments to this Manuals

No comments

Kohler K-1188-RE-0 Installation Guide Page 17

Comments to this Manuals

Related products and manuals for Unknown Kohler K-1188-RE-0