Kohler K-1257-VBR-96 Installation Guide download pdf (Page 16)

10. Install the User Interface

Push a thin nail into the oriﬁce in the user interface and separate the user interface from the

mounting plate.

Position the mounting plate over the cable and against the ﬁnished wall so the two hooks are to the

left, as shown in the ″Front View″ image above. Then level the mounting plate and mark the screw

hole locations on the wall.

Remove the mounting plate without allowing the cable to fall between the walls, and drill 1/4″

holes at the marked screw hole locations.

Insert the provided wall anchors into the holes.

Apply a bead of silicone sealant to each of the sealant grooves on the back of the mounting plate.

Position the mounting plate over the cable with the hooks to the left, and secure the mounting plate

to the wall using the two screws provided.

Check for level. Loosen the screws and adjust the mounting plate as needed until it is level.

Retighten the screws.

Connect the cable to the user interface.

Engage the user interface with the two mounting plate hooks, then ﬁrmly swing the user interface

against the mounting plate until they snap together.

Refer to the User Guide included with the product to set up, program, and verify proper function of

the product.

Anchors

Horizontal and

Vertical

Adjustment

Hooks

Screws

Pencil

Silicone

Sealant

Front ViewBack View

Mounting

Plate

User

Interface

1188012-2-C 16 Kohler Co.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 59 60

No comments

Kohler K-1257-VBR-96 Installation Guide Page 16