Kohler K-1914-GRW-0 Installation Guide Page 51
- Page / 168
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Troubleshooting (cont.)
Symptoms Probable Causes Recommended Action
H. The wire connections are loose. H1. Check the power cord from the
outlet to the controller.
H2. Check the drain valve power cord
to the controller.
H3. Check the level probe wiring to the
controller.
H4. Check the limit switch wiring to
the controller.
H5. Check the door power cord to the
controller.
I. The internal wire connections
inside the door are loose.
I. Call the Customer Care Center
using the information provided on
the back page of this manual.
J. The primary seal system is not
operating properly or the air
line may be pinched.
J. Call the Customer Care Center
using the information provided on
the back page of this manual.
K. The secondary seal systems are
not operating properly or the air
line may be pinched.
K. Call the Customer Care Center
using the information provided on
the back page of this manual.
L. There is an air leak inside the
door.
L. Call the Customer Care Center
using the information provided on
the back page of this manual.
M. The compressor is not working. M. The compressor needs to be
replaced. Call the Customer Care
Center using the information
provided on the back page of this
manual.
N. The pressure switch inside the
door is not working or is
leaking air.
N. Call the Customer Care Center
using the information provided on
the back page of this manual.
O. The controller is not working. O. The controller needs to be replaced.
Call the Customer Care Center
using the information provided on
the back page of this manual.
17. Water splashes off the
drip tray onto the floor.
A. The brush seal is not installed
or is not adjusted correctly.
A. Install or adjust the brush seal.
B. The bath is not leveled properly. B. Check the back ledge and the sides
of the bath for level. Adjust the feet
until the bath is level if needed.
C. The door gap is too big because
the pulley assembly is not
properly adjusted.
C. Adjust the pulley assembly inward.
D. Water is splashing over the top
of the seal.
D. Lower the water level when filling
the bath. Reduce sudden
movements when bathing.
18. Door will not stay in the
raised position.
A. One or both counterweights are
not attached.
A. Attach the counterweight(s).
B. Door bumper needs adjustment. B. Adjust the door bumper as needed.
C. The mounting bracket is not
adjusted properly.
C. Adjust the mounting brackets
inward using the slots.
Kohler Co. 51 1128535-2-F
- Installation Guide 1
- Important Information 2
- Factory-Assembled Features 3
- Table of Contents 4
- Tools and Materials 4
- Before You Begin 5
- Parts Identification 6
- 1. Construct the Framing 7
- 2. Confirm the Correct Cutout 9
- All Installations 10
- 5. Remove the Door 13
- 1128535-2-F 16 Kohler Co 16
- 7. Remove the Receptor Tray 17
- 8. Disconnect the Components 18
- Kohler Co. 19 1128535-2-F 19
- 9. Position the Bath 20
- 10. Level and Secure the Bath 22
- 12. Install the Receptor Tray 24
- 14. Install the Door 28
- 15. Attach the Counterweights 29
- 16. Connect the Components 31
- 17. Adjust the Bath Door 32
- GFCI-Protected Receptacle 36
- Power Supply 36
- Heating Surface 36
- 20. Confirm Airjet Operation 37
- Keypad Operation 38
- 22. Install the Finished Wall 41
- Troubleshooting 41
- Guide d’installation 54
- Notices du produit 55
- Pièces assemblées en usine 55
- Sommaire 56
- Outils et matériaux 56
- Avant de commencer 57
- Identification des pièces 58
- 1. Construire la charpente 59
- Toutes les installations 61
- 5. Retirer la porte 65
- 7. Retirer le bac collecteur 69
- 8. Déconnecter les composants 70
- 9. Positionner la baignoire 72
- 14. Installer la porte 80
- 15. Attacher les contrepoids 81
- 16. Connecter les composants 83
- Alimentation électrique 88
- Surface de chauffage 88
- Fonctionnement du clavier 89
- 22. Installer le mur fini 95
- Dépannage 95
- Guía de instalación 110
- Avisos sobre el producto 111
- Contenido 112
- Herramientas y materiales 112
- Antes de comenzar 113
- Identificación de las piezas 114
- Todas las instalaciones 115
- 5. Retire la puerta 121
- 8. Desconecte los componentes 126
- 9. Coloque la bañera 128
- 10. Nivele y fije la bañera 130
- 14. Instale la puerta 136
- 15. Fije los contrapesos 137
- 16. Conecte los componentes 139
- Tomacorriente protegido 144
- Superficie de calefacción 144
- Funcionamiento del teclado 145
- 22. Instale la pared acabada 151
- Guía para resolver problemas 151
- 1128535-2-F 166
Related products and manuals for Unknown Kohler K-1914-GRW-0
Unknown Kohler K7160AFCP User's Guide
(24 pages)
(24 pages)
Unknown Kohler K9000CP Specifications
(2 pages)
(2 pages)
Unknown Kohler K7160AFCP Specifications
(2 pages)
(2 pages)
Unknown Kohler K7160AFCP User's Guide
(1 pages)
(1 pages)
© 2020, manymanuals.com. All rights reserved. | 0.588 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals