Kohler K-2461-F2 Installation Guide download pdf (Page 7)

4. Install the Lavatory

Install the faucet to the lavatory following the faucet

manufacturer’s instructions.

Properly seat the lavatory on top of the vanity. The back of the

lavatory must be ﬂush against the ﬁnished wall.

Push down on each corner of the lavatory to make sure it does

not rock from side to side on the vanity.

NOTE: If adjustment is needed, remove the lavatory and set it aside.

Use a screwdriver to turn the levelers on the vanity. Seat the

lavatory on the vanity. Repeat this procedure, if necessary.

Remove the lavatory from the vanity and set it aside.

CAUTION: Risk of product damage. Siliconized acrylic caulk must

be used to secure the lavatory to the vanity. Do not use 100%

silicone sealant, which will damage the ﬁnish of the vanity.

Apply a 1/8″ (3 mm) thick bead of water-based caulk around the

top edge of the vanity.

Carefully position the lavatory on top of the vanity.

Apply a small bead of water-based caulk to the top edge where

the lavatory contacts the wall. Allow the caulk to dry before

proceeding. Refer to the manufacturer’s instructions for

recommended drying time.

Connect the drain and supplies.

Leveler

Apply sealant.

Kohler Co. 7 1061218-2-A

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

No comments

Kohler K-2461-F2 Installation Guide Page 7