Kohler K-702202-L-SHP Installation Guide download pdf (Page 5)

1. Measure and Cut the Bottom Track

WARNING: Risk of personal injury. Always wear safety glasses when cutting materials.

NOTICE: Risk of product damage. Do not cut the top track at this time. The top track dimension is not

the same as the bottom track.

IMPORTANT! If your shower has a curve in the corners where they meet the sidewalls, be sure to

measure from wall to wall above the curves. Failure to measure above the curve or angle could result in

the bottom track being cut too short.

Measure from wall to wall at the ﬂattest part of the shower ledge (dimension ″D″).

Mark dimension ″D″ on the bottom track.

IMPORTANT! For best results, use a 32-teeth hacksaw blade and a miter box to cut the bottom track.

On the end opposite the mark, align the end of the insert ﬂush with the end of the bottom track.

Subtract 1-1/8″ (2.9 cm) from dimension ″D″ and simultaneously cut the bottom track and insert to

this dimension.

File the rough edges smooth where the bottom track was cut, taking care not to mar the ﬁnished

surface.

NOTE: If there are curves where the sidewalls meet the threshold, use a ﬁle to contour the bottom track

edges to match the curves as necessary.

Measure

Here.

Measure

Here.

Measure distance

"D" above curves in

the corners.

Measure carefully. If your walls are curved or

angled, measure above the curve or angle. Failure

to do so can result in an improperly cut bottom

track and can void the warranty.

Curved Base

Important:

Angled Base

Kohler Co. 5 1054857-2-B

1 2 3 4 5 6 7 8 9 10 ... 47 48

No comments

Kohler K-702202-L-SHP Installation Guide Page 5