Kohler K-706002-L-SH Installation Guide download pdf (Page 11)

8. Install the Door Handle

Press the glass bushings into the handle holes in the operating panel.

Identify the interior handle - the handle with holes going all the way through. Insert two ﬂathead

screws through this handle and through the holes in the operating glass panel. Slide the bushings

onto the screws.

Align the exterior handle holes with the screws. Tighten the screws from the inside until snug using

the 5/64″ hex wrench provided.

NOTICE: Do not overtighten. Overtightening can cause damage to the operating panel.

9. Install the Strike Jamb Seal and the Threshold Seal

NOTICE: Risk of product damage. Do not install the threshold seal under the hinge or the door will not

operate properly.

Insert the strike jamb seal into the strike jamb channel. Trim the excess seal from the top.

Remove the masking tape from the threshold.

Starting at the strike jamb side, install the threshold seal into the groove on the threshold. The seal

runs from the end to the front of the hinge. Notch the foam portion around the strike jamb. Trim the

excess seal at the hinge.

Screw

Bushing

Exterior Handle

Strike Jamb

Threshold

Install the strike jamb seal,

and trim the excess.

Strike Jamb

Seal

Interior

Handle

Threshold

Seal

Install the threshold seal.

Notch the foam portion of the

seal around the strike jamb.

Trim the excess threshold

seal at the hinge.

Kohler Co. 11 1011451-2-F

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

No comments

Kohler K-706002-L-SH Installation Guide Page 11