Kohler K-158-3-CP Installation Guide download pdf (Page 3)

1. Install the Spout and Handspray

NOTE: Before applying plumbers putty or other sealant to the

escutcheon, make sure the O-ring is in place in the groove on the

interior surface.

Apply a bead of plumbers putty or other sealant to the underside

of the escutcheon according to the manufacturer’s instructions.

Thread the shank nut and washer to the bottom of the shank.

Insert the shank from the bottom of the sink.

Slide the escutcheon over the shank.

Thread the spout to the bottom of the shank, then loosen the

spout 1/8 of a turn.

Loosen the shank 1/8 of a turn.

IMPORTANT! Do not loosen the shank more than 1/2 turn. The

spout may not seal, resulting in a leak.

Tighten the nut and washer to secure the spray holder to the sink.

Slide the gasket (provided) onto the spray holder.

Slide the spray holder through the mounting hole from above.

Securely hand tighten the nut to the spray holder from under the

sink.

Insert the handspray hose through the spray holder.

Attach the handspray hose to the shank tee using thread sealant.

Handspray

Nut

Sink

Shank Nut

Washer

Spout

Shank

Escutcheon

O-Ring

Handspray

Hose

Shank Tee

Spray Holder

Apply

plumbers

putty.

Kohler Co. 3 1015072-2-D

1 2 3 4 5 6 7 8 ... 23 24

No comments

Kohler K-158-3-CP Installation Guide Page 3