Kohler COMMAND CH18-745 User Manual download pdf (Page 141)

8.24

Section 8

Electrical System and Components

3. Again referring to Figure 8-31, grasp the spring

retainer and push it toward the starter,

compressing the anti-drift spring and exposing the

retaining ring.

4. Holding the spring retainer in the retracted

position, assemble the inner halves of the

removal tool around the armature shaft with the

retaining ring in the inner groove (see Figure

8-32). Slide the collar over the inner halves to

hold them in position.

Figure 8-32. Assembling Inner Half of Tool Around

Armature Shaft and Retaining Ring.

5. Thread the center screw into the removal tool until

you feel resistance. Use a wrench (1-1/8" or

adjustable) to hold the base of the removal tool.

Use another wrench or socket (1/2" or 13 mm) to

turn the center screw clockwise (see Figure 8-33).

The resistance against the center screw will tell

you when the retaining ring has popped out of the

groove in the armature shaft.

Style ‘‘B’’ Drive Service

1. The rubber dust cover has a molded lip on the

inside that snaps into a groove in the dust cover

spacer (see Figure 8-31). Turn the drive pinion

clockwise until it reaches the fully extended

position. While holding it in the extended position,

grasp the tip of the dust cover with a pliers or vise

grip and pull it free from the spacer.

Dust Cover

Retaining

Ring

Anti-Drift

Spring

Drive

Pinion

Drive Nut

(Collar)

Dust Cover

Spacer

Spring

Retainer

Figure 8-31. Drive Components, ‘‘Bonded’’ Inertia

Drive Starter.

2. Disassemble the snap ring removal tool, SPX Part

No. KO1049 (formerly Kohler Part No.

25 761 18-S).

Figure 8-33. Holding Tool and Turning Center

Screw (Clockwise) to Remove Retaining Ring.

6. Remove the drive components from the armature

shaft, paying attention to the sequence. If the

splines are dirty, clean them with solvent.

7. The splines should have a light film of lubricant.

Relubricate as necessary with Kohler bendix

starter lubricant (Part No. 52 357 01-S). Reinstall

or replace the drive components, assembling

them in the reverse order they were removed.

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 217 218

Comments to this Manuals

No comments

Kohler COMMAND CH18-745 User Manual Page 141

Comments to this Manuals

Related products and manuals for For the car Kohler COMMAND CH18-745