Kohler COMMAND CH18-745 User Manual download pdf (Page 195)

11.10

Section 11

Reassembly

Install Supports for the Metal Grass Screen

1. If a metal grass screen is used, with threaded

individual supports, install a spacer washer on the

external threads. Apply blue Loctite

No. 242

(removable) onto the threads. Install the four

supports as shown in Figure 11-32.

Figure 11-32. Installing Supports for Metal Grass

Screen.

2. Tighten the supports with a torque wrench to

9.9 N·m (88 in. lb.). See Figure 11-33. The grass

screen will be installed to the supports after the

blower housing is in place.

Figure 11-33. Torquing Supports for Metal Screen

(Some Models).

Install Hydraulic Lifters

1. See ‘‘Servicing Hydraulic Lifters’’ in Section 10 for

lifter preparation (bleed down) procedures.

2. Apply camshaft lubricant (Kohler Part No.

25 357 14-S) to the bottom surface of each lifter.

See Figure 11-34. Lubricate the hydraulic lifters

and the lifter bores in the crankcase with engine

oil.

Figure 11-34. Applying Camshaft Lubricant to

Bottom of Lifters.

3. Note the mark or tag identifying the hydraulic

lifters as either intake or exhaust and cylinder 1 or

cylinder 2. Install the hydraulic lifters into their

appropriate location in the crankcase. Do not use

a magnet. See Figure 11-35.

NOTE: Hydraulic lifters should always be

installed in the same position as before

disassembly. The exhaust lifters are

located on the output shaft side of the

engine while the intake lifters are located

on the fan side of the engine. The

cylinder numbers are embossed on the

top of the crankcase and each cylinder

head. See Figure 11-36.

Figure 11-35. Installing Hydraulic Lifters.

1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 217 218

Comments to this Manuals

No comments

Kohler COMMAND CH18-745 User Manual Page 195

Comments to this Manuals

Related products and manuals for For the car Kohler COMMAND CH18-745