Kohler COMMAND CH18-745 User Manual download pdf (Page 203)

11.18

Section 11

Reassembly

Figure 11-65. Tighten Baffle Mounting Screws.

6. The metal grass screen can now be attached to

the supports.

Figure 11-64. Tighten Short Screws to Torque

Specified.

Figure 11-66. Installing Metal Type Grass Screen.

7. Torque the four breather cover screws to 7.3 N·m

(65 in. lb.) in the sequence shown in Figure

11-67.

4. If the rectifier-regulator was not removed, attach

the ground wire or metal grounding bracket for the

rectifier-regulator, using the silver colored screw

and washer, to the lower blower housing hole.

See Figure 11-63.

Figure 11-63. Ground Lead Details.

5. Tighten all of the shrouding fasteners. Torque the

blower housing screws to 6.2 N·m (55 in. lb.) in a

new hole, or to 4.0 N·m (35 in. lb.) in a used hole.

Torque the shorter M5 side baffle screws to 4.0

N·m (35 in. lb.). See Figure 11-64. Torque the

upper M5 side baffle screws (into cylinder head)

to 6.2 N·m (55 in. lb.) in a new hole, or to 4.0 N·m

(35 in. lb.) in a used hole. Torque the two rear M6

baffle mounting screws to 10.7 N·m (95 in. lb.) in

a new hole, or to 7.3 N·m (65 in. lb.) in a used

hole. See Figure 11-65.

1 2 ... 198 199 200 201 202 203 204 205 206 207 208 ... 217 218

No comments

Kohler COMMAND CH18-745 User Manual Page 203